Are they real brick?

• Yes, our brick tiles are cut from the full sized brick so we get 2 bricks tiles per brick. Due to this they are identical to the full sized brick in every way except for thickness as we have cut them into a tile format.

​

How many brick facings do I need?

• Estimating how many brick facings you need is really quite easy. Multiply the height (m) and width (m) of the wall or the width (m) and breadth (m) of the floor area you need covered, this will allow you to calculate the square meters required. If you want to covert this to individual facings, multiply the square meterage by 60 (this assumes a 10mm mortar gap), for on mesh systems, divide this number by the sq. m of each sheet (0.18m sq. m. for brick thins and 0.24 sq. m for cobbles).  We advise that you order 10% more than required to allow for wastage during installation.

​

How are they installed?​

• You lay them just like normal tiles.......instructions on how this is done can be found here.

 

Can they be used in wet areas?​

• Yes you can use them in wet areas but we do suggest you seal them.. 

​

What can brick tiles be be stuck to?

• Lots of surfaces including cement sheeting, pre-existing masonry, concrete and pre-formed systems such as hebel. 

 

Can they be used externally?​

• Yes they can be used externally.

​

Can they be used internally?​

• Yes they can be used internally.

​

Are they suitable for floors?

• Yes, the following brick tiles are suitable for floors and have a P5 slip rating (thats a good rating btw):
  -Reclamation Federation Clinkers
  -Palomino
  -Old Red Wirecuts
  -Ochre
  -Weathered Parliament
  -Rome Thins & Rome Cobbles
  -Prague Thins & Prague Cobbles
  -Wellington Thins
  -Jerusalem Thins

​

What adhesive do you use?​

• Typically standard tile adhesive but see our instructions for further details.